Fountain care guide

A fountain only works if the water in it is worth drinking. The good news is that looking after one takes about two minutes a week, and most of that is rinsing.

Here is what to do, and how often.

Every day

Top the water up. A fountain loses water to evaporation faster than a bowl does, because the water is moving and has far more surface area. Running a pump dry is the quickest way to kill it, so keep the level above the minimum mark.

While you are there, glance at the flow. If it looks weaker than it did yesterday, the filter is probably due.

Every week

Empty the fountain, rinse the bowl and the lid under warm running water, and wipe them down with a soft cloth or a brush you keep for the job.

Skip the washing up liquid if you can. Any residue left behind changes the taste, and some cats will quietly refuse the water because of it. If you do use soap, rinse twice.

Pay attention to the places water sits still: the underside of the lid, the lip of the bowl, and the channel the water runs down. That is where a slippery film forms first.

Every two to four weeks

Change the filter. Most carbon and foam filters are spent somewhere in that window. Sooner if more than one pet drinks from it, if you live in a hard water area, or if your pet starts drinking less, which is often the first sign that the water has gone flat.

Do not rinse a carbon filter and put it back. Once the carbon is loaded it stops taking anything out of the water and starts holding on to what it already collected.

Every month or two

Take the pump apart and clean it properly. Most pumps come apart into a cover, an impeller and a housing. Pull the impeller out, rinse it, and clean the shaft with a cotton bud or the small brush that came with your fountain.

Limescale and hair collect around the impeller, and that is almost always what turns a quiet pump into a humming one.

In a hard water area, soak the pump parts in one part white vinegar to three parts water for about fifteen minutes, then rinse them thoroughly and let them dry before putting everything back together.

If something is not right

It has gone noisy

Nine times out of ten the water is low. Top it up first. If it is still noisy, the impeller needs cleaning or is not seated properly. Check that nothing has wrapped around it.

The flow has dropped

Usually a clogged filter or a clogged pump inlet. Change the filter, then rinse the inlet screen.

There is a slimy film

That is biofilm, and it forms in anything that holds water. It is not a sign that something is wrong with the fountain, only that the weekly clean is overdue. Scrub it off rather than rinsing, because water alone will not lift it.

Your pet has stopped using it

Check the taste first. An old filter or soap residue are the usual culprits. Then check where it is standing. Then give it time. Some cats take a week to decide a new fountain is trustworthy.

Where to put it

  • Away from the food bowl. Many cats prefer to drink somewhere separate from where they eat.
  • Well away from the litter tray.
  • Somewhere quiet, but not hidden. A corner your pet already walks through beats a spare room.
  • On a hard floor or a mat rather than a rug. Fountains splash a little.

What water to use

Tap water is fine in most places. In a hard water area, filtered water will slow the limescale building up on the pump and mean less descaling for you. Avoid using distilled water day to day, since the minerals have been taken out of it.

One last thing

A fountain makes it easier for a pet to drink more. A sudden change in how much your pet drinks, in either direction, is worth mentioning to your vet. It is one of the more useful things you can notice at home.